威海探探上约多少钱一晚-威海探探上约多少钱一晚_主页

在江门酒店晚上怎么叫服务

Yaobuwei brick waterproof agent

2019-07-09 15:07:24 five thousand one hundred and fifty-eight
 Yaobaoshi - waterproof agent without breaking bricks in kitchen

Product overview: yaobaoshi - non smashing waterproof agent for bathroom, kitchen, shower, swimming pool, etc. which has been pasted with floor tiles (including pipe root part seepage).
Product type: type I waterproof agent and type II waterproof agent

Main components: component A is mainly composed of inorganic silicate and penetration AIDS; component B is mainly composed of calcium solution and crystallization AIDS.

The main function of the water-proof brick (A-H) is to block the water leakage under the floor by the chemical reaction of component A and component H. In the sand brick floor, the water permeable layer in the sand brick layer below is the water permeable channel.

Scope of application: This product is suitable for the water seepage of toilet, kitchen, shower room, swimming pool, etc. which have been pasted with floor tiles (including pipe root part seepage)

Warranty period: more than 10 years

Features and advantages:
· do not smash bricks, save time, effort and money;
· low viscosity and good fluidity, which can penetrate into each seepage channel under the ceramic tile;
It is more than 10 years, resistant to acid and alkali, and resistant to water;
· pure inorganic substance, safe and environmental protection, meeting the drinking water standard.
· compared with type I waterproof agent, type II waterproof agent solution can reach the structural layer and recrystallize, effectively solve the problem of floor leakage of settlement toilet, and soak once in the construction process, which is convenient for construction.

Construction process of type I waterproof agent
1. Use the art knife, hacksaw blade or cutting machine to cut the floor tile joint (conducive to the penetration of waterproof agent), with a depth of 5-10 mm, and clean up the dirt.
2. Block the floor leakage.
3. Dilute component A with 3 times of water, pour it on the floor, and sweep it from low to high with a broom until it all leaks under the floor.
4. After 2-3 hours, the excess component A shall be released and cleaned. After diluting component B with 3 times of water, it shall be poured on the floor and swept from low to high until the liquid level does not drop any more.
5. Release the residual component B, clean the ground and finish the construction.
6. The water storage test can be carried out 3 days after the completion of construction (the water level shall not be higher than the liquid level of the product during construction).

Construction process of type II waterproof agent
1. Use the art knife, hacksaw blade or cutting machine to cut the floor tile joint (conducive to the penetration of waterproof agent), with a depth of 5-10 mm, and clean up the dirt.
2. Block the floor leakage.
3. Pour component a into a large bucket and dilute it with 2 times of water. Then pour component B into another bucket and dilute it with 2 times of water. Then pour diluent B into diluent A and mix well while pouring.
4. Pour the mixture on the floor, sweep it from low to high for about 1 hour, and then soak it for 4-8 hours to clean up the gel residue on the surface, and the construction is finished.
5. The water storage test can be carried out 3 days after the completion of the construction (during the water storage test, the water level cannot be higher than the liquid level of the product during construction).